1999 OLDSMOBILE 98 4DR SEDAN
Security
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Starter01 YEL + (+) IGN SW HAR
AllDoorTrigger DR.BLU (-) LOW IN DRV KICK,TAN(-)IN DRV DOOR BOOT
TrunkTrigger LT.BLU (-) (-) AT RAC MODULE "BEHIND RHT SIDE OF DASH"
FactoryAlarmDisarm LT.GRN (-) DRIVER'S KICK PANEL
ParkingLights BRN (+) AT LIGHT CONTROL MOD LFT OF STEERING COL
Remote Start
Battery RED + (+) IGNITION SWITCH HARNESS
Ignition PNK (+) IGNITION SWITCH HARNESS
Ignition02 LT.GRN + (+) IGNITION SWITCH HARNESS "ACC2"
Ignition03 +
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL + (+) IGN SW HAR
AntiTheftSystem NONE
Tach VIO/WHT (-) (-) AT CCCI MODULE "BEHIND RHT SIDE OF DASH"
SpeedSense GRN/WHT 4000 (AC) DRIV REAR QTR BLU 80 PIN CONN POS 13
ParkingLights BRN (+) AT LIGHT CONTROL MOD LFT OF STEERING COL
BrakeLights LT.BLU/BLK (+) AT BRAKE SWITCH
Horn BLK (-) AT STEERING COLUMN
Doorlocks / Window
PowerUnLock ORN/BLK (-) (-) NEGATIVE TRIGGER
PowerLock RED/BLK (-) (-) DRIVER'S DOOR HARNESS
Convenience
HeadLights YEL (+) AT LIGHT SWITCH
LowSpeedWipers VIO (+) AT STEERING COLUMN
TrunkRelease BLK (+) AT SWITCH BY COLUMN
Mobile Audio / Video
Battery RED + (+) IGNITION SWITCH HARNESS
Accessory01 ORG + (+) IGNITION SWITCH HARNESS
Ground BLK/WHT - (-) RADIO HARNESS
Illumination GRY/BLK (+) RADIO HARNESS
Dimmer BRN/WHT (+) RADIO HARNESS
PowerAntenna DK.GRN (+) RADIO HARNESS
FrontLeftSpeakerPos TAN
FrontLeftSpeakerNeg GRY
FrontRightSpeakerPos LT.GRN
FrontRightSpeakerNeg DARK GREEN
RearLeftSpeakerPos BRN
RearLeftSpeakerNeg YEL
RearRightSpeakerPos DK.BLU
RearRightSpeakerNeg LT.BLU
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
